﻿The behaviour of the switching output at the end of the disabling function can be configured.

*no change of switching state*: The relay of the output shows no reaction and remains in the state last set by the disabling function.

*Switch off*: At the end of the disabling function, the switching output is switched off and enabled again.

*Switch on*: At the end of the disabling function, the switching output is switched on and enabled again.

*Set tracked state*: The last switching state received during the disabling function or the switching state set before the disabling function will be tracked. Any time functions still in progress will also be taken into account if necessary.

*Flash*: The switching output is switched on and off cyclically after the disabling. The time for flashing is generally configured for all outputs on the parameter page "General -> General switching outputs". During flashing, the logical switching state of the output is fed back as "Switched on". The flashing state remains active until another KNX command is received and thereby predefines another switching state. 
